DUOMAT 3
Installation
68010(b)
25
6.2.3
Dismantling
CAUTION
Work on electrical components should be conducted only when the mains power con-
nection is unplugged.
Certain details may change as a result of technical changes.
1
Move your product into a position where it is supporting no load.
CAUTION
Be sure to carry out work on the drive in a position so that no loads are bearing on it.
Only in this way can you be sure to avoid any risks of crushing or injury.
2
Pull out the mains power plug!
CAUTION
Disconnect the batteries if you are using the battery-operated reset function. Discon-
nect the nine-volt block batteries.
3
Disconnect all additional components such as slave drives or handset from their sockets.
4
Pull strongly on the shutters to the side (A).
5
Pull out the DUOMAT 3 far enough so that the brackets (D) are out of the slots (B). The
DUOMAT 3 is now unattached and can be removed.
NOTICE
Be sure to support the drive's weight to prevent it falling.
6
Push the shutters (A) back onto the DUOMAT 3 so that they are not lost during transportation.
