Phoenix Mecano Dewert Okin DUOMAT 9, Руководство по установке

Страница: 33 / 44

DUOMAT 9 Operating notes
79338 4.0 33
If you have purchased the DUOMAT 9 with the mechanical reset function (rotary switch or Bowden
cable), then you should note the following:

In the event of a power failure or emergency, the head and foot sections can be lowered me-
chanically using the mechanical reset function.

Follow the instructions on the sticker on the back of the DUOMAT 9 (refer to Figure 19).

Turn the rotary switch only when the unit is not operating.

Use the Bowden cable only when the unit is not operating.

Relieve the pressure on the head/foot section by raising it up.

Once the head/foot section is in this unloaded state, turn the rotary switch to the mechanical re-
set position. Turn the rotary switch so that the desired section of your end product is selected:
= Lowering head section,
= Lowering foot section (optional),
= Lowering head and foot sections (optional),
= Normal mode.

Depending on the design of the head and foot sections, the section may lower merely from its
own weight. If the head or foot sections do not lower themselves by their own weight, you will
need to help the section down by applying light pressure to the end product.

Turn the rotary switch back to normal mode; the drive is ready for use again.

Only turn the rotary switch when the unit is not operating. (The drive motor or motors must not
be running!)
NOTICE
If you are installing the DUOMAT 9 with a mechanical reset function in your end prod-
uct, then it is essential that you use mechanical end stops to limit the bottom end point
motion. Mechanical damage to the drive system will result if end stops are not used.