Phoenix International 8711 West Port Avenue Milwaukee, WI 53224 +1 414.973.3400 [email protected]
dryrod.com
Type 24 Series
Flux Cored Electrode Wire Stabilization Ovens
Operating Instructions
Operating Instructions
6
N5610275B
06.25.19
Phoenix Ovens International LLC warrants its products against defects in material and workmanship. The company will, at its discretion, repair or replace any properly installed Phoenix International
manufactured product which fails under normal operating conditions within one year from date of receipt. Contact the factory for return authorization before returning the product to Phoenix
International freight prepaid. If our inspection confirms that the product is defective under terms of this warranty, it will be repaired/replaced and returned freight prepaid.
This warranty applies only to products sold by Phoenix International, Inc. and specifically excludes installation or de-installation labor, transportation or equipment of another manufacturer used in
conjunction with Phoenix International products. No other warranty, expressed or implied, exists beyond this warranty declaration.
Phoenix constantly strives to improve its products and therefore reserves the right to change design, materials and specifications without notice.
Warranty
Wiring
Eliminate expensive rework and protect welding profits!
This guide explains proper storage and oven holding temperatures:
• Recondition/rebake procedures for electrode coatings exposed to moisture are included.
• Remove electrodes from cardboard containers before placing in ovens.
• Electrode coatings should not be exposed to the re-baking temperature without first being reconditioned at a lower temperature. Failure to do so may result
in breakdown of electrode coatings. After re-baking, lower temperature to holding level until reissued.
Download your guide at
www.dryrod.com/guide.
Guide to Electrode & Flux Stabilization
Wiring Diagram for
Type 24 Series 480V
Wiring Diagram for
Type 24 Series 240V
CAUTION
•
All wiring should be done by a licensed electrician in accordance with state codes, local codes, and National Electrical Code (NEC) or International Electric
Commission (IEC) standards.
•
Improper installation or use may result in serious injury.
•
Always remove oven from power source before troubleshooting or repairing.
heating element
red
green
heating element
white fiberglass
insulated
thermostat
indicator
light
white fiberglass
insulated
fiberglass sleeving
white
black
white fiberglass
insulated
white fiberglass
insulated
14/4 SEO
cord
red
green
black
black
white
white
junction box
green
power in
thermostat
indicator
light
white fiberglass
insulated
heating element
heating element
white fiberglass
insulated
white fiberglass
insulated
red
green
white
black
fiberglass sleeving
red
black
black
white
white
power in
14/4 SEO
cord
green
junction box
green
