Type 300HT Series
Electrode Stabilization Ovens
Operating Instructions
Operating Instructions
6
Phoenix International 8711 West Port Avenue Milwaukee, WI 53224 +1 414.973.3400 [email protected]
dryrod.com
N5466102B
02.08.19
Phoenix Ovens International LLC warrants its products against defects in material and workmanship. The company will, at its discretion, repair or replace any properly installed Phoenix International
manufactured product which fails under normal operating conditions within one year from date of receipt. Contact the factory for return authorization before returning the product to Phoenix
International freight prepaid. If our inspection confirms that the product is defective under terms of this warranty, it will be repaired/replaced and returned freight prepaid.
This warranty applies only to products sold by Phoenix International, Inc. and specifically excludes installation or de-installation labor, transportation or equipment of another manufacturer used in
conjunction with Phoenix International products. No other warranty, expressed or implied, exists beyond this warranty declaration.
Phoenix constantly strives to improve its products and therefore reserves the right to change design, materials and specifications without notice.
Warranty
Wiring
Note: Jumper wires must be installed outside of insulation.
Thermometer probe wire (not shown) must be installed outside
of insulation.
CAUTION
•
All wiring should be done by a licensed electrician in accordance
with state codes, local codes, and National Electrical Code (NEC)
or International Electric Commission (IEC) standards.
•
Improper installation or use may result in serious injury.
•
Always remove oven from power source before troubleshooting
or repairing.
Eliminate expensive rework and protect welding profits!
This guide explains proper storage and oven holding temperatures:
• Recondition/rebake procedures for electrode coatings exposed to moisture are included.
• Remove electrodes from cardboard containers before placing in ovens.
• Electrode coatings should not be exposed to the re-baking temperature without first being reconditioned at a lower temperature. Failure to do so may result
in breakdown of electrode coatings. After re-baking, lower temperature to holding level until reissued.
Download your guide at
jumper
1 of 2
thermal
couple probe
heating
element
pilot light
white
black
green
conduit
box
Guide to Electrode & Flux Stabilization
Wiring Diagram for Type
300HT Series 120V
Wiring Diagram for Type
300HT Series 240V
pilot light
heating
element
thermal
couple probe
black
green
white
conduit
box
jumper
2 of 2
variable thermostat
variable thermostat
