Phoenix Gold • www.phoenixgold.com
Amplifier Owner’s Manual
Ti2 1300.1
MonoBlock Power Amplifier
INPUT
Connect preamp signal cables from the head unit to these terminals.
CROSSOVER FREQUENCY
Controls the lowpass crossover point for the speaker outputs.
BASS BOOST
Variable bass boost from 0 to +18dB @ 45Hz.
REMOTE BASS LEVEL CONTROL (RBC)
This port is for connecting the remote subwoofer level control. This allows
up to 20dB of volume adjustment. This is not a bass boost, it controls the
level of the low pass signal.
NOTE: This control is not compatible with the Phoenix Gold LPL44 level
control.
SENS
Used to reach maximum amplifier power with a wide variety of headunits.
SUBSONIC CROSSOVER FREQUENCY
Controls the highpass crossover point for the speaker outputs to eliminate
extreme low frequencies.
REMOTE MONITORING DISPLAY (RMD)
Connect optional RMD Voltage Display to this port..
PHASE
This allows the phase of the output to be adjusted from 0 to 180 degrees. This
adjustment can help achieve better “up front” subwoofer bass and resolve
subwoofer cancellation problems in certain installations. Each installation is
different, slowly adjust and listen for best results.
+12V
This must be connected to the fused positive terminal (+12V) of the car’s
battery. The fuse must be located within 18 inches of the battery.
REMOTE
This must be connected to sw12V, usually a trigger wire coming
from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car’s battery or
bolted to a clean, unpainted part of the chassis of the vehicle.
SPEAKER OUTPUTS
Used to connect the amplifier to speakers. Ti21300.1’s minimum
impedance is 1 ohm.
CLIP INDICATORS (located on top of the amplifier)
Lights when the amplifier reaches near maximum output. Under heavy
use the clip indicators should be flashing during the peaks of the
music. The clip indicator should not stay lit for long periods of time (more
than 1 or 2 seconds), if this is the case you need to reduce system volume
or level of the amplifier.
Note: The Ti21300.1 has a variable speed fan located on the power
endpanel.
