Phoenix Contact TP 6000 HMI, Руководство пользователя

Страница: 9 / 30

Installation
4109_en_B PHOENIX CONTACT
7/28
3 Installation
3.1 Mounting
The TP 6…PS can be mounted in a panel or attached to a VESA mount. Use the appropriate
section below to install the TP 6…PS.
3.1.1 Panel mount
NOTE:
Observe the following notes during installation:
When installing the device, leave a gap of at least 30 mm around the device to ensure
sufficient air circulation.
When the operating device is installed horizontally, please note that additional sourc -
es of heat beneath the operating device may result in heat accumulation.
Make sure to allow sufficient heat dissipation!
Please observe the permissible temperature range specified in the technical data
when operating the device.
In order to ensure the degree of protection specified in the technical data, observe the
following points:
– A tolerance of ±0.5 mm is maintained for the mounting cutout.
– The seal lies flat against the mounting surface.
– The number of mounting brackets, given in the technical data, is used.
– The material of the mounting surface is sufficiently stable to ensure permanently
secure attachment of the operating device.
– The mounting surface and the operating device may not become deformed due to
the effects of the mounting clamps or through the operation of the device.
– The threaded pins of the mounting brackets are tightened uniformly to a maximum
torque of 1 Nm.
When installing the TP 6…PS in a cabinet, follow these general rules:
– Verify clearances within the cabinet. Typically, allow at least 5 cm (2 in.) on each side
of the TP 6…PS.
– Drill all holes and make all cuts before beginning installation.Be sure to protect already
installed components from metal shavings.
– Supporting panels must be at least 1.9 mm (14 gauge) to provide proper support.
– Make sure there is adequate space around the heat sink on the unit and air inlets/out -
lets to provide sufficient cooling.