Phoenix Contact THERMOMARK ROLL 2.0, Руководство пользователя

Страница: 15 / 54

Starting up the printer
108716_en_01 PHOENIX CONTACT
15 / 52
2.4.3 Inserting the ink ribbon
Figure 2-5 Feed path of the ink ribbon
The ink ribbon is only required for thermal transfer printing . Clean the printhead before
inserting the ink ribbon (see “Cleaning the printhead” on page 36 ).
Inserting the ink ribbon • To lift the printhead, turn the green lever (3) counterclockwise.
• Push the ink ribbon roll onto the supply hub (1) so that the color coating of the film faces
downwards during unwinding.
• The Phoenix Contact ink ribbon rolls for this printer have the color coating on the out-
side of the winding. Observe the unwinding direction shown in Figure 2-5 . If the color
coating is positioned incorrectly, the film will stick to the printhead.
• Push the empty core of an ink ribbon roll onto the take-up hub (2).
• Guide the ink ribbon through the printing unit as shown in Figure 2-5 . Guide the ink rib-
bon through above the label sensor.
• Secure the starting end of the ink ribbon centrally on the empty core of the ink ribbon
roll using adhesive tape. Observe the counterclockwise running direction of the take-up
hub.
• To tighten the feed path of the ink ribbon, turn the take-up hub counterclockwise.
• To close the printhead, turn the green lever clockwise.
3
2
1