CUTFOX 10
18
PHOENIX CONTACT
102786_en_03
3.5
Adjusting or replacing the rollers
Adjusting the clamping pressure of the drive rollers (B)
The clamping pressure must suit the cable. For standard ca-
ble, it does not need to be changed.
The following generally applies:
–
Hard and thick material: more pressure
–
Soft and thin material: less pressure
•
Press the door opener and fold down the front door.
•
Set the clamping pressure with the adjusting screw.
Rotate left
more pressure
Rotate right
less pressure
Replacing drive or metering rollers
•
Press the door opener and fold down the front door.
•
Insert the removal hook (1) supplied behind the rollers
(2) and push off the rollers.
•
Replace the rollers (for ordering data see page 20).
•
Fold up the front door.
•
Plug in the mains plug again.
B
B
A
B
B
WARNING: Risk of injury
Switch off the CUTFOX 10 and disconnect the
mains plug.
NOTE:
Replace the drive rollers (B) in pairs on-
ly.
Pay attention to the flat guiding surface (3)
when mounting.
Содержание CUTFOX 10
Страница 1: ...Original operating instructions Operation of the Cutting Machine CUTFOX 10...
Страница 2: ......
Страница 22: ...CUTFOX 10 22 PHOENIX CONTACT 102786_en_03...