Phoenix Contact BWP 2043W, Руководство пользователя

Страница: 11 / 34

Installation and Commissioning
108593_en_00 PHOENIX CONTACT
11
2 Installation and Commissioning
2.1 Unpacking the Device
Unpack all parts carefully and check the contents for any visible damage in transit. Also
check whether the shipment matches the specifications on your delivery note.
If you notice damages in transit or discrepancies, please contact us immediately.
2.2 Mounting the Device
The device enables quick and easy mounting. A panel thickness of 1 mm to 6 mm is permit-
ted for proper mounting.
NOTICE: Damage
When installing the device, leave a gap of at least 30 mm (1.181") around the device to
ensure sufficient air circulation.
NOTICE: Damage
When the operating device is installed horizontally, please note that additional sources of
heat beneath the operating device may result in heat accumulation.
Make sure to allow sufficient heat dissipation!
Please observe the permissible temperature range specified in the technical data when
operating the device.
NOTICE: Damage
In order to ensure the degree of protection specified in the technical data, observe the fol-
lowing points:
– A tolerance of +0,5 / -0 mm is maintained for the mounting cutout.
– The seal lies flat against the mounting surface.
– All mounting brackets are used.
– The threaded pins of the mounting brackets are tightened uniformly to a maximum
torque of 0,4 Nm.