Phocos Any-Grid Series, Руководство пользователя и инструкция по установке

Страница: 33 / 36

www.phocos.com 32 | P a g e
Figure 32: RS485 ports on inverter Figure 33: Communication connector
Connection steps :
1. Connect the communication connector configured for the inverter to the RS485 terminal of the inverter, as
shown in Fig 34:
Figure 34: RS485 cable connection
2. According to above, connect the communication connector pinout and the user's device, make sure the
connection is correct.
3. Please download the monitoring software and its operation instructions from www.phocos.com.
Optional Communication
The optional communication modes include Ethernet, WiFi, GPRS and ENET, which also need corresponding
communication parts and components as shown in the table below (sold separately). All operation parameters of the
inverter are output from port “RS485-M” to the communication devices, and finally transmitted to the monitoring
system as standard Ethernet, WiFi, GPRS and ENET signals.
Optional Accessory Inverter Port Final Communication Type
Ethernet converter RS485-M RJ45 Ethernet port
WiFi converter RS485-M WiFi signal
GPRS RS485-M GPRS signal
ENET RS485-M Ethernet port
Please ask for further instructions and how to purchase and use these accessories separately from your dealer.
9.0 Troubleshooting
This chapter describes the fault alarms and fault codes for quick troubleshooting.