Service Modes, Error Codes, and Fault Finding
5.
5.
Service Modes, Error Codes, and Fault Finding
Index of this chapter:
5.1 Test Points
5.2 Service Mode
5.3 Error Codes
5.5 Software Upgrading
5.1
Test Points
This chassis is NOT equipped with test points in the service
printing. These test points are NOT specifically mentioned in
the service manual.
5.2
Service Mode
5.2.1
Factory Mode or Service Alignment Mode (SAM)
How to Enter
To enter the Factory mode, use the following method:
•
Press on the remote control the code “
062596
” directly
followed by the “
INFO
” key.
After entering the Factory mode, the following screen is visible,
the values can be adjusted according to the requested (see
Chapter 8).
Figure 5-1 Factory mode menu, System
Figure 5-2 Factory mode menu, Balance
Figure 5-3 Factory mode menu, TV Geometry
Figure 5-4 Factory mode menu, Nicam
Figure 5-5 Factory mode menu, Mono
I_179
3
0_055.ep
s
24040
8
I_179
3
0_056.ep
s
24040
8
I_179
3
0_057.ep
s
24040
8
I_179
3
0_05
8
.ep
s
24040
8
I_179
3
0_059.ep
s
24040
8
Содержание TCM1.0E
Страница 18: ...Service Modes Error Codes and Fault Finding EN 18 TCM1 0E LA 5 Personal Notes E_06532_012 eps 131004 ...
Страница 38: ...38 TCM1 0E LA 7 Circuit Diagrams and PWB Layouts Layout Small Signal Board Top Side I_17930_022 eps 220408 ...
Страница 39: ...Circuit Diagrams and PWB Layouts 39 TCM1 0E LA 7 Layout Small Signal Board Bottom Side I_17930_023 eps 220408 ...
Страница 44: ...44 TCM1 0E LA 7 Circuit Diagrams and PWB Layouts Personal Notes E_06532_013 eps 131004 ...