6
3
With the help of another person, place the
mount against the wall and level it using the
bubble guide.
4
While another person holds the mount in
place, mark six locations on the wall where
the mount is to be installed.
5
Set the mount aside and drill a 3/8” (10
mm) pilot hole at each marked location.
Remove any excess dust from the holes.
6
Insert a concrete anchor (P) into each hole
so that it is flush with the concrete surface.
A hammer can be used to lightly tap the
anchors into place if necessary.
7
Place the mount back against the wall and
secure it using the lag bolts (Q) and lag bolt
washers (R) provided. Do not over-tighten
these bolts and do not release the mount
until all bolts are in place.
2
2
8
Once all (6) lag bolts are in place you must
tighten each one. Be sure not to over
tighten.
D
Note
If the concrete wall is covered
by a layer of plaster or drywall,
the concrete anchor must pass
completely through the layer to rest
flush with the concrete surface.
3.3 Attaching the arms to the display
B
Warning
Use extra care during this part of the
installation. Avoid laying your display
face down if possible as it may damage
the viewing surface.
1
Examine the back of your television.
If the back of your display is flat:
You
will be using one of the shorter bolts from
the hardware kit.
3
3
If the back of your display is curved
or recessed:
You will be using one of the
longer bolts and a spacer.
4
4
2
Determine the correct diameter bolt to
use by trying one bolt each from Bags 1
- 4 of the hardware kit. Do not force any
of the bolts – if you feel resistance stop
immediately to avoid damaging your display.
SQM5822-27_Manual.indb 6
2009-7-22 11:18:18
