Philips Senseo Latte Duo HD6570/60/B, Руководство по обслуживанию

Страница: 6 / 25

HD6570/60 /B
6-25
Disassembly- and Reassembly advice
Remove the brewhead.
•
Unhook the 3-way valve from the Brew chamber back
frame and undo the hose from the 3-way valve to the
brew chamber.
• Unhook the boiler from the boiler support on the Brew
chamber bottom.
• The Brew head can now be tilted forward and removed
from the appliance.
Remove the PCBA
• To be able to remove or replace the PCBA it is the easiest
to open the appliance up until you have the Brew head
removed.
• Carefully unplug all connectors on the lower right side
of the PCBA for the NTC’s, Brew head switch and water
level sensor.
•
Disconnect the Brown and Blue lead from the Cordset on
the left side of the PCBA
• Undo all fixed leads from their routing through the
frame. They are going to: Boiler, Thermo block, Steam
pump and Water pump.
• The PCBA is held in place by one screw ( E ) in the center
of the PCBA.
Open the brew head lid
• To be able to open the lid of the brew head, remove the
front, back and side covers.
• Disconnect the UI cable from the Main PCBA ( J3 ) to the
brewhead, and undo its routing through the inner frame.
• Undo the hose from the 3-way valve to the brew head.
• Use a flathead screwdriver to unhook one side of the
hinges of the brew head lid. Carefully feed the hose and
cable through the frame.
• To open the lid, undo the eight snaphooks holding the
lid in place. To be able to remove the lid completely the
lever needs to be in the Open position (flipped up).
Note: Please make very sure that all wires you have
undone will be put back properly and with
the same routing as they have originally been
designed.
Note: Any tie-wrap that has been cut must be replaced
by a new one as specified on the Parts list, and
tightened with a force of 115 N.