Philips SDV4310/27, Руководство пользователя

Страница: 5 / 28

5
ENGLISH
4.1 Assembly and installation
1
Attach the two piece reflectors together
using four bolts and wing nuts provided.
D Note
Be sure wing nuts are on outside of the
reflector.
1
2
Extend the folded drive element by carefully
folding the “wings” outward so they are at
90 degrees to the boom. Then place the
unattached end over the lead-in terminal.
2
3
Attach Transformer to bottom studs of drive
elements with wing nuts and washers.
3
4
Slide the reflector screen onto the boom
from the rear until the screw holes of the
screen bracket line up with the holes on
the top and bottom of the boom.
Attach the screen to the boom using two
(2) 1-1/2” bolts, lockwashers and wing nuts.
E
Tip
To make the fit easier when sliding the screen
onto the boom, squeeze the top and bottom of
the screen toward each other.
5
Insert end caps at end of boom.
4
6
Attach the antenna to the mast: Assemble
U-bolt to cross piece. Attach U-bolt
assembly loosely to antenna, using saddle,
lockwashers and nuts. Insert mast through
U-bolt. Tighten nuts securely.
4
7
Connect 2 mast sections as shown.
5
1
Folded
drive
element
Lead-in terminal
2
Lead-in terminal
Wing Nut
Transformer
Washers
3
Assembled
Antenna
Saddle
Nut
Lockwasher
Cross Piece
U-Bolt
End Cap
Mast
4
5