Philips SBC RU 530, Инструкция по эксплуатации

Страница: 6 / 78

Setting the remote control
This is only necessary if your appliance does not respond to the RU530.
If that is the case, the RU530 does not recognize the brand and/or model of
your appliance and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.
You can repeat the same steps for other appliances
(VCR, satellite or cable decoder) which you want to operate using the
RU530.
Example of TV:
1
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2
Look up the brand of your TV in the code list at the back of this
manual. One or more four-figure codes are shown for each brand.
Note the first code.
Be careful! There are separate tables for TV,VCR and SAT.
Make sure you use the codes from the correct table.
3
Select TV with the mode selector.
(See ‘Testing the remote control’.)
4
Keep keys ‘1’ and ‘3’ pressed simultaneously
for three seconds until the green light under
TV in the selector window flashes twice and
then remains lit.
5
Then enter the code noted in step 2 using the digital keys.
– The green light in the selector window will now flash twice.
If the light flashes once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
6
Point the RU530 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the RU530 is ready for
use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
M
EN
U OK
SHIFT
1 2 3
4 5 6
7 8
0
9
TV VCR SAT
6
Instructions for use
English
XP SBC RU 530/87.3 09-02-2004 15:31 Pagina 6