Blocked shaving heads
If the shaving heads are blocked, the shaving unit symbol and the tap
symbol with exclamation mark flash. In this case, the motor cannot
run because the shaving heads are soiled or damaged. (Fig. 19)
Note: The displays of types RQ1062, RQ1060, RQ1052 and RQ1050 look
different but show the same indication.
When this happens, you have to clean the shaving unit or replace it.
The shaving unit symbol and the tap symbol with exclamation mark
continue to flash until you unblock the shaving heads.
Charging
Charging takes approx. 1 hour.
A fully charged shaver has a shaving time of up to 65 minutes, which is
enough for approx. 21 shaves.
The actual shaving time is calculated by the shaver. If you have a heavy
beard, the shaving time may be less than 65 minutes. The shaving time
may also vary over time, depending on your shaving behaviour and beard
type.
Quick charge
After the shaver has charged for 5 minutes, it contains enough energy for
one shave.
Put the small plug in the Power Pod (Fig. 0).
Put the adapter in the wall socket.
Pull at the top of the lid () and remove it () (Fig. ).
4
First insert the top of the shaver into the Power Pod () and then
press the bottom part into the Power Pod () (Fig. ).
Note: The shaver cannot be placed in the Power Pod when the protection cap
is on the shaving unit.
The display shows that the shaver is charging (see chapter ‘The
display’).
-
-
-
,
English
Содержание RQ1090/20
