Philips PT722/21, Руководство пользователя

Страница: 28 / 44

27
- The shaver complies with the internationally approved IEC safety
regulations and can be safely cleaned under the tap.
The shaver and the Jet Clean System comply with all standards -
regarding electromagnetic fi elds (EMF). If handled properly and
according to the instructions in this user manual, they are safe to use
based on scientifi c evidence available today.
general
The appliance is equipped with an automatic voltage selector and is -
suitable for mains voltages ranging from 100 to 240 volts.
The adapter transforms 100-240 volts to a safe low voltage of less than -
24 volts.
Charging
It takes approx. 1 hour to fully charge the shaver.
When you charge the shaver for the fi rst time or after a long period of
disuse, let it charge until the battery light lights up continuously.
A fully charged shaver provides up to 50 shaving minutes.
The shaving time may be less than 50 shaving minutes as a result of your
shaving behaviour, your cleaning habits or your beard type.
Charge indications
Battery low
- When the battery is almost empty (when there are only 5 or fewer
shaving minutes left), the battery light starts to fl ash orange.
When you switch off the shaver, the battery light continues to fl ash -
orange for a few seconds.
Quick charging
- When you start charging the empty battery, the battery light fl ashes
green and orange.
Note: When the battery light fl ashes green and orange towards only green, you
can have a quick shave of three minutes.
Charging
- When the shaver is charging, the battery light fl ashes green.
Battery fully charged
- When the battery is fully charged, the battery light lights up green
continuously.
Note: After approx. 30 minutes, the battery light goes out to save energy.
Charging with the adapter
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
The battery light shows the charging status of the shaver (see
,
section ‘Charge indications’ in this chapter).
Charging in the Jet Clean system
1 Put the small plug in the Jet Clean System.
2 Put the adapter in the wall socket.
3 Place the shaver without protection cap upside down in the shaver
holder.
Note: The shaver cannot be placed in the Jet Clean System when the protection
cap is on the shaving unit.
4 Push down the locking lever completely to lock the shaver into place.
The battery symbol on the Jet Clean System fl ashes to indicate that
,
the shaver is being charged.
Note: When the Jet Clean System is performing the cleaning program, the
battery symbol is out.
,
When the battery is fully charged, the battery symbol on the Jet
Clean System lights up continuously.
Note: After approx. 30 minutes, the battery symbol goes out to save energy.
English English
- The shaver complies with the internationally approved IEC safety
regulations and can be safely cleaned under the tap.
The shaver and the Jet Clean System comply with all standards -
regarding electromagnetic fi elds (EMF). If handled properly and
according to the instructions in this user manual, they are safe to use
based on scientifi c evidence available today.
general
The appliance is equipped with an automatic voltage selector and is -
suitable for mains voltages ranging from 100 to 240 volts.
The adapter transforms 100-240 volts to a safe low voltage of less than -
24 volts.
Charging
It takes approx. 1 hour to fully charge the shaver.
When you charge the shaver for the fi rst time or after a long period of
disuse, let it charge until the battery light lights up continuously.
A fully charged shaver provides up to 50 shaving minutes.
The shaving time may be less than 50 shaving minutes as a result of your
shaving behaviour, your cleaning habits or your beard type.
Charge indications
Battery low
- When the battery is almost empty (when there are only 5 or fewer
shaving minutes left), the battery light starts to fl ash orange.
When you switch off the shaver, the battery light continues to fl ash -
orange for a few seconds.
Quick charging
- When you start charging the empty battery, the battery light fl ashes
green and orange.
Note: When the battery light fl ashes green and orange towards only green, you
can have a quick shave of three minutes.
Charging
- When the shaver is charging, the battery light fl ashes green.
Battery fully charged
- When the battery is fully charged, the battery light lights up green
continuously.
Note: After approx. 30 minutes, the battery light goes out to save energy.
Charging with the adapter
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
The battery light shows the charging status of the shaver (see
,
section ‘Charge indications’ in this chapter).
Charging in the Jet Clean system
1 Put the small plug in the Jet Clean System.
2 Put the adapter in the wall socket.
3 Place the shaver without protection cap upside down in the shaver
holder.
Note: The shaver cannot be placed in the Jet Clean System when the protection
cap is on the shaving unit.
4 Push down the locking lever completely to lock the shaver into place.
The battery symbol on the Jet Clean System fl ashes to indicate that
,
the shaver is being charged.
Note: When the Jet Clean System is performing the cleaning program, the
battery symbol is out.
,
When the battery is fully charged, the battery symbol on the Jet
Clean System lights up continuously.
Note: After approx. 30 minutes, the battery symbol goes out to save energy.
English English
PT729CC_A6_CS3.indd 27 13.4.26 2:47:16 PM