ProScreen
PXG10
PXG10
ProScreen
Big picture...
eye fo r d e t a i l
3122 435 64760
Design and specif
ications ar
e subject to c
hang
e without notice
Replacing the lens:
www.philipsusa.com
Handling precautions:
Do not disassemble this projector;
Please refer any maintenance and inspections, requiring an open cabinet to your authorized dealer.
Care:
Installation of new replacement lenses should be conducted in a dust free environment to avoid
dust particles entering the optical path between the lens and projector;
When cleaning the lens use compressed air or lens cleaning material;
Avoid cleaning the lens with abrasive materials as this may scratch the lens surface.
Use the “LENS” on the remote control or controls on projector
to select the mode for “FOCUS”. Press till the end (outermost)
position where lens adjustment is no longer possible, and then
power the projector “OFF”. (See “SET UP” “Lens adjustment” in
User Guide for precise instructions).
Press and hold the lens clasp located under the lens housing, then
grasp the lens and turn it slowly fully counter clockwise.
The lens can now be removed.
Before proceeding confirm that the projectors’ lens mount is
properly aligned (A and B in this illustration).
Remove the replacement lens from its original carton.
Line-up the markings on the replacement lens (C = small groove
and D = ridge) in this illustration, being the focus ring turned to the
most counter clockwise position), and then insert the replacement
lens into the projectors’ lens housing.
Before proceeding, check that the replacement lens markings
(D and E in this illustration), are concealed in the lens housing.
Turn the replacement lens clockwise slowly and confirm that the
clasp is at the very bottom of the lens housing.
Otherwise the lens may fall off during transportation.
1
2
3
4
5
6
TEST PTRN
NEXT
ADJUST
FOCUS
TEST PTRN
NEXT
ADJUST
FOCUS
B
D
C
A
B
C
D
D
E
A
More Information
Fax Information System:
(865) 521-4341
Technical Support:
toll free 1-888-873-4672 (USA)
Sales Information:
1-888-327-3636