17
16
The learning feature allows you to “learn” functions
from your original remote control. For example - you may
want to use your remote to operate the RANDOM PLAY
feature from your original CD remote control. This
remote is equipped with an “easy learning” feature that
allows you to “learn” features (such as RANDOM PLAY
from your original CD remote) by following the steps
below, and on the next page:
1. Press and hold the
CODE SEARCH
button until the
red indicator turns on, then release the button.
2. Press and release the desired mode button (
TV
,
VCR
, etc.), the red indicator blinks then stays on.
3. Press and release the
LEARN
button, the red
indicator blinks then stays on.
4. Press and release the
Learning Remote
button that
you want to teach (e.g.
POWER)
.
5. Point both remotes facing each other by approxi-
mately 1 inch apart (see tips on page 14).
6. Press and hold the
Original Remote
button (e.g.
Power) until the red indicator blinks once and stays
on. If there is a learning problem, the indicator blinks
for three seconds and stays on. If this happens,
repeat Steps 4 to 6.
7. Repeat Steps 4-6 for other buttons you want to
learn.
8. Press and release the
CODE SEARCH
button when
all desired remote commands are learned. Code
Learning is now complete.
2.
3.
4.
6.
Learning Commands
Line up your remotes (that you’re learning from) in front of
the Learning remote, on a hard surface approx. 1 inch apart.
This feature assists you in identifying where your
original remotes IR transmitter is located and is
particularly useful if your original remote’s IR
transmitter is hidden behind a lens.
1. Point both remotes facing each other by
approximately 1 inch apart (see Tips on Learning on
previous pages)
2. Press and hold the
CODE SEARCH
button until the
red indicator turns on, then release the button.
3. Press and release the desired Mode button (
TV
,
VCR
, etc.), the red indicator blinks then stays on.
4. Press and release the
LEARN
button, the red
indicator blinks then stays on.
5. Press and hold any
Original Remote
button and
move the
Original Remote
to the left and right, and/
or, up and down in front of the Learning remote IR
transmitter. The red indicator will remain on if no IR
from the Original remote is found and the red
indicator will blink on and off more rapidly when the
IR transmitters are lining up. The point where the
red indicator blinks most rapidly is where the two IR
transmitters are aligned. Note some original remotes
will only transmit IR on the initial button press then
stop. In these cases, quickly press and release the
original remote button repeatedly during this
procedure.
6. You can now learn a button from your original
remote by continuing from “
Step 4
” in the
“
Learning Commands
” section on the next page, or,
to exit at this point, press and release the
CODE
SEARCH
button
IR Transmitter Finder Feature
1.
