Philips PerfectCare Azur GC4919/86, Руководство пользователя

Страница: 10 / 42

4 Wind the mains cord around the cord winding area and fix it with
the cord clip. Put the mains cord below the CordFix indication to
ensure the mains cord does not touch the hot soleplate during
storage.
5 Store the iron on its heel in a safe and dry place.
Troubleshooting
This chapter summarises the most common problems you could have with
the appliance. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked
questions or contact the Consumer Care Centre in your country.
Problem Possible cause Solution
The iron cannot
remove wrinkles from
the garment.
There is no steam during ironing. Put water inside the water tank. Set the
steam slider to MAX.
Water drips from the
soleplate after the iron
has been unplugged or
has been stored.
The steam slider is set to MAX. Set the steam slider to ‘no steam’.
You have put the iron in
horizontal position with water
still left in the water tank.
Empty the water tank.
The light on the iron is
amber instead of blue,
and keeps flashing.
The Calc-Clean reminder light
has been activated. This is a
regular reminder for you to
descale the appliance.
Perform the Calc-Clean process (see
chapter ‘Cleaning and maintenance’, section
‘Calc-Clean System’).
The SmartLight
pulsates slowly.
The Safety Auto-off mode is
active. The iron has switched
to standby mode (see chapter
‘Safety Auto-off’).
Move the iron to reactivate it. The iron
starts heating up again. Start ironing again
only when the SmartLight lights up steadily.
Dirty water and
impurities come out
of the soleplate during
ironing.
Hard water with impurities or
chemicals has formed flakes
inside the soleplate.
Use the Calc-Clean function one or
more times (see chapter ‘Cleaning and
maintenance’, section ‘Calc-Clean System’).
The iron is plugged
in, but the soleplate is
cold.
There is a connection problem. Check the mains cord, the plug and the
wall socket.
The iron does not
produce any steam.
There is not enough water in
the water tank.
Fill the water tank (see chapter ‘Preparing
for use’, section ‘Filling the water tank’.
The steam slider is set to ‘no
steam’.
Set the steam slider to MAX (see chapter
‘Preparing for use’, section ‘Steam settings’).
ENGLISH
12