4
EN
5
EN
2
Getting started
2.1 Inserting the batteries
•
Insert 2 AAA type batteries,
noting the + and -
configuration in the battery
compartment.
Note
When replacing the batteries, all user settings will be
retained in the remote control memory for 5 minutes.
2.2 Setting up the universal remote control
The example below instructs you how to set up your
universal remote control for your TV.
You can repeat the same steps for other devices (STB, DVD
player/recorder and VCR) which you want to operate, using
the SRP3004.
The remote control can be set up to operate any 4 of the
following devices:
Device name
Description
TV
Traditional TV, flat screen TV and
projection TV, TV part of TV / VCR, TV /
VCR / DVD and TV / DVD combos
STB
Cable box, satellite receiver, Digital
Video Broadcasting Terrestrial device
(DVB-T), Internet Protocol TV
(IPTV), Free To Air TV, High Definition
Television decoder (HDTV)
DVD
DVD player / recorder (DVDR), DVD /
Hard Disk Drive combination (DVDR-
HDD), Blu-Ray player, High Definition
DVD player (HD-DVD), DVD part of
TV / DVD, TV / VCR / DVD and VCR /
DVD combos
VCR
Video cassette player / recorder, VCR
part of TV / VCR, TV / VCR / DVD and
VCR / DVD combos
Example: setting up the universal remote control to
operate your TV:
1
Switch ON
the TV manually or use the original remote
control for this. Tune to channel 1.
2
Press and hold
the
device selection button
for 5 seconds
until it blinks
twice and then remains lit.
• The remote control is
now in setup mode.
3
Look up the 4-digit
code for your brand in the
brand list at the back of this
user manual.
A four-digit code is shown
for each brand.
Use the digit buttons to
enter the code for your
brand.
• The key will now
blink twice and then
remains lit.
If the key blinks twice fast, the code has not been
entered properly or the wrong code has been
entered. In this case, try again.
4
Aim the remote control at
the TV.
Press and hold
the
button. Release it
immediately
release it as
soon the TV switches off.
• This may take up to 30
seconds.
5
Switch ON
the TV.
Try out the buttons you
need for operating it. Try, for
example, if the
- PROG +
and digit buttons function
properly.
• If a button does not work as expected,
press and hold
that button. Release it
immediately
as soon as it works.
For more information, see chapter
2.2.2
.
6
Press the device
selection button
twice
to
finish setup.
•
When no button is
pressed for 2 minutes
or more, the remote
control will exit setup mode, automatically saving all
your settings.
Getting
star
ted
English
5 sec.
2 x
30 sec.
