25
26
Trimming eyebrows with the eyebrow
combs
1
Comb your eyebrows in the direction of hair
growth (Fig. 12) .
2
Choose the short or long comb, depending
on the desired hair length.
- short comb: 3mm/0.12in
- long comb: 5mm/0.2in
Tip: We advise you to start trimming with the long
comb. If you think your eyebrows are still too long
after this, use the short comb.
3
Slide the eyebrow comb onto the nose/ear/
eyebrow trimming head (Fig. 13) .
Make sure that the eyebrow comb has been
properly slid into the grooves on both sides.
4
Move the comb over the eyebrow from the
outer tip of the eyebrow towards the base
of the nose (against the direction of hair
growth) (Fig. 14) .
ENGLISH
Cleaning
Clean the appliance immediately after use and
when a lot of hair or dirt has accumulated on the
cutting element.
Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as
petrol or acetone to clean the appliance.
Do not tap on the cutting element.
Do not use any sharp objects to clean the cutting
element.
1
Make sure the appliance is switched off.
2
Rinse the cutting element of the nose/
ear/eyebrow trimming head with hot
water (Fig. 15) .
3
Switch on the appliance and rinse the cutting
element once more to remove any remaining
hairs. Then switch off the appliance again.
Tip: The best way to clean the cutting element is
to immerse it in a glass with warm water for a few
minutes and then switch on the appliance (Fig. 16) .
ENGLISH
NT3160-10̲A7̲JP̲cs6.indd 26
14/12/08 14:08
