ENGLISH
C
4
Shake off any excess water from shaver
before placing in the SmartClean System.
C
5
Hold the shaver head side down above the
shaver holder with the display facing the
shaver holder.
C
6
Place the shaver into the holder (1), push
shaver back (2) and press down the top
cap to connect the shaver (3) (click).
The shaver will only fit in the SmartClean System
in one direction.
7
The battery symbol blinks slowly to
indicate shaver is charging.
C
8
Press the ON/OFF button ( ) on the
SmartClean System to start the cleaning
cycle.
The cleaning symbol will blink.
◗
The cleaning cycle takes approximately 10
minutes.
◗
Do not press the ON/OFF button while the
cleaning cycle is running. If this does occur, the
cleaning cycle will stop and the cleaning symbol
stops blinking. The cleaning cycle can
be re-started by pressing the ON/OFF button
once.
29
ENGLISH
When the SmartClean System is ready for use,
do not move appliance to prevent leakage.
Cleaning the Shaver in the
SmartClean System
◗
If the shaver does not contain enough power
for one (1) shave, the SmartClean System
may not work properly. Charge the shaver
in the SmartClean System before using the
SmartClean System to clean your shaver.
◗
If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
1
Connect the small plug to the SmartClean
System. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
2
. Place the SmartClean System on a flat,
level surface. Make sure the seal has been
removed from the cleaning cartridge (see
‘Preparing SmartClean System For Use’).
C
3
Press the top cap down to open the
SmartClean System.
28
1
2
3