Philips Norelco 3405LC, Руководство пользователя

Страница: 6 / 7

6. 7.
4 Brush the inside of housing and Razor Head Assembly.
5 Replace the Razor Head Assembly back on razor.
Every Two Months: Razor Heads
1 Turn razor OFF and disconnect from outlet.
2 Remove Razor Head Assembly off housing unit.
3 Brush the inside of the housing.
4 Turn Razor Head Assembly over so that the
underside is exposed.
5 Press down and turn wheel of frame counterclockwise.
6 Remove the frame and brush clean.
7 Slide and remove one cutter and head at a time to clean.
• Be careful not to mix up cutters and heads.They
are a matched set and if interchanged, it will greatly
affect shaving performance.
8 Separate the cutter from the head.
9 Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
10 Brush the slots of the razor head.
For optimum performance, razor cutters and heads
should be cleaned in a degreasing liquid (e.g. Norelco
Razor Cleaner or alcohol) and lubricated with Norelco
Razor Lubricant, model AL80, or one drop of mineral oil
(in the center of the head).
11 Replace the cutter into head section. Slide razor head
back into frame making sure that flat rim of cutting
heads slides under 2 clamps on frame.
12 Repeat the process for the other two razor heads
(cutters and heads).
13 Replace the frame.
14 Press down and turn the wheel clockwise until it locks
into place.
15 Replace the Razor Head Assembly back on razor.