First Time Setup 9
Where Do You Start?
1
Disconnect all equipment
from power. Connect equipment to
power only after you have finished hooking up everything. Do not
change connections with equipment connected to a power outlet.
2
Put the batteries in the remote control and connect the
AM and FM antennas as detailed below.
3
Connect the DVD Receiver to a Television using one of the
options detailed in your separate Quick-Use Guide (or on
pages 10-12).
●
You need only one video connection between the DVD Receiver
and the TV. Use Composite Video (good picture quality), S-Video
(better picture), or Component Video (best picture). Use the best
connection available with your TV.
●
Set the TV to the correct VIDEO IN channel. Such channels
may be called AUX(iliary) IN, AUDIO/VIDEO (A/V) IN, EXT1, S-
VIDEO, etc. These channels are often near channel 00 on your
TV. Or, your TV remote control may have a button or switch that
chooses different Video modes. With some TVs, you use the TV’s
menu to select a Video mode. See your TV manual for details.
4
Connect the speakers and Subwoofer to the DVD Receiver
as detailed in your Quick-Use Guide (or on page 13).
Battery Installation
1
Remove the battery compartment lid
by pressing in the tab,
then lifting off the lid.
2
Place the batteries in the battery compartment,
matching
the +/- markings on the batteries to the +/- markings inside the
remote.
3
Replace the battery compartment lid.
Antenna Connections
1
Connect the supplied AM loop antenna to the AM jack on
the rear of the DVD Receiver.
●
Reposition the loop antenna to receive the clearest sound for area
stations. Attach the antenna to the base stand if desired.
2
Connect the supplied FM antenna to the FM jack on the
rear of the DVD Receiver.
Extend and adjust the antenna until
the clearest station signal is received. For better FM reception, use a
75 ohm coaxial cable (not supplied) to connect the DVD Receiver
to an outdoor FM antenna as shown.
1
3
2
AM
FM
(75
Ω)
Outdoor FM
Antenna
(not supplied)
OR
Put the claw
into the slot.
75
⍀
Rear of TV
75
⍀
75
⍀
Note: If your TV only has a single Antenna
In(put) jack,
you will need an accessory RF
Modulator to view the DVD playback on your
TV. See your electronics retailer or contact
Philips for details on RF Modulator availability.
• To prevent unwanted noise,
keep the antenna as far away
as possible from the TV, VCR,
or any other radiation source.
Helpful Hint
