18
English
Preparations
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3
Close the cover.
Using the remote control to operate the
system
1
Point the remote control directly at the remote
sensor (iR) on the front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE, TUNER).
3
Then select the desired function
(for example
2;
,
í
,
ë
).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
1
Go to Standby mode.
2
Press and hold
CLOCK SET
.
➜
“
SET CLOCK
” will appear, followed by ““
0
:
00
”.
3
Press
VOLUME -/+
on the system to set the
hours.
4
Press
CLOCK SET
again.
5
Press
VOLUME -/+
on the system to set the
minutes.
6
Press
CLOCK SET
to confirm your setting,
and then go into standby mode. The system will
store the setting automatically.
➜
The time setting becomes effective.
To exit the setting without storing
●
Press
STANDBY ON
to exit setting mode and
go into
STANDBY
mode.
●
You can also press
SOURCE
to exit setting
mode and go into disc mode.
●
The system will also exit setting mode and go to
tuner, AUX, tape mode when you press the
corresponding source button.
Note:
– The clock will be cancelled when the power cord
is disconnected or if a power failure occurs.
Содержание MCD280
Страница 1: ...MCD280 DVD Micro Hi Fi System ...
Страница 4: ...4 1 2 6 3 4 5 6 7 0 7 9 8 ...
Страница 5: ...5 1 2 3 ª 5 4 6 7 0 9 8 ...
