2-1
2-1
DISMANTLING INSTRUCTIONS
Dismantling of the DVD Loader
1) The tray can be manually open by inserting a minus
screw driver and push the lever in the direction as shown
in Figure 1 to unlock the tray before sliding it out.
2) Slide out the tray and remove the Cover Tray assembly
(pos 110 + pos 111 + pos 112) as shown in Figure 2.
3) Loosen 5 screws to remove the Cover Top (pos 240).
- 1 screw each on the left & right side (pos 272)
- 3 screws on the rear (pos 270)
Dismantling of the Tuner Module & Speaker Connector Board
1) Loosen 2 screws A (see Figure 4) to remove the Tuner
Module (pos 1105).
2) When the Tuner Module (pos 1105) become defective
and need to be replaced, make sure the Lug of the Tuner
Module is bend as shown in Figure 3.
Note : The Lug of the Tuner Module is purposely bend in
this way (see Figure 3) to prevent damage to the
Flex Cable.
3) Loosen 2 screws B (see Figure 4) to remove the Speaker
Connector Board (pos 1102).
1) Loosen 4 screws E and uncatch C1 (see Figure 5) to
remove the PSU Board (pos 1104).
2) Loosen 4 screws F (see Figure 5) to remove the Amplifier
Board (pos 1107).
3) Loosen 2 screws G (see Figure 5) to remove the SD6.1
RX Board (1103-1001).
Dismantling of the PSU Board, Amplifier Board, SD6.1 RX Board & AV Board
Figure 6
4) Loosen 4 screws D (see Figure 5) to remove the DVD
Loader (pos 1103-0001).
Figure 4
Figure 5
Figure 7
Figure 3
Figure 2
Figure 1
4) Loosen 2 screws H and uncatch C2 (see Figure 6) to
remove the Shield AV (pos 180).
5) Loosen 5 screws C (see Figure 4) and uncatch 2 catches
C3 (see Figure 7) to remove the AV Board (pos 1101).
