7
Mounting LTC 0330/x1, LTC 0350/x1, LTC 0430/x1, and
LTC 0450/x1 fixed lens cameras in LTC 9480, LTC 9483
Series Housings
3c. Remove the mounting block from the camera by removing
the two small screws that attach the foot to the camera. Use
a small straight blade screw driver to remove these screws.
See
Figure 5
.
Figure 5 Removing the Camera Foot
3d. Attach the lens to the camera.
3e. Mount the camera to the camera bracket using the two
screws removed from the foot. Use the slots in the camera
bracket to accomplish this. See
Figure 6
.
Note:
The hardware kit contains a spacer block. This spacer
block can be used to raise the camera off the camera bracket.
Simply place the spacer block between the camera and the
camera bracket and through the screws. This is only necessary in
very few instances when the lens may hit the camera bracket.
Figure 6: Mounting the Camera
For installation of zoom lens cameras mounted in LTC
9488 Series Housings:
3f. Attach the lens to the camera.
3g. Use the various 1/4-20 screws and spacers provided to
mount the camera and the lens to the camera bracket.
6.8
Camera/Lens Wiring
WARNING: Only use the cables specified under
"INSTALLATION, Cable Requirements" for wiring
of all cameras and lenses.
6.8.1
Fittings
1. The two large 1/2-in NPT fittings accept round cable with
diameters from 4.3 mm (0.17-in) to 11.9 mm (0.47-in).
The small fittings will accept cables with diameters from
4.6 mm (0.181-in) to 7.9 mm (0.312-in).
Be sure to securely tighten all fittings to ensure a
liquid-tight seal. Failure to do so could allow water to
enter the housing and damage the camera and lens.
If a sealant is to be used, be sure it is a neutral cure type.
Sealants that release acetic acid may harm camera electronics.
Use of "drip loops" is recommended on the wiring
outside of the rear end cap.
6.8.2
Conduit
These housings are designed to allow conduit to be directly
connected.
1. Remove the rear fittings and attach the conduit and conduit
fittings directly to the housing rearcap. The holes accept
1/2-in conduit fittings and PG 13.5 conduit fittings. Any
unused holes can be covered using the plugs provided in the
hardware kit.
6.8.3
Feed-through Wiring
These housings have the capability of having the cabling feed
through the foot of the housing. This requires the use of feed-
through mounts like the LTC 9215/00, LTC 9219/01.
1. Prior to mounting the camera. Remove the two dome plugs
located inside the housing. See
Figure 7
.
