Mechanical Instructions
4.
4.3.7
1080p Panel
1.
Refer to next figure(s).
2.
Unplug cables [a]. Be careful with the LVDS connectors as
they are very fragile.
3.
Remove the fixation screws [b].
4.
Take the board out (it hinges at the lower side).
5.
Remove the screws [c] that fixate the top and bottom
shieldings, and remove the shieldings.
Note:
Pay special attention not to damage the EMC foams.
Ensure that EMC foams are mounted correctly, especially
notice the large EMC foam “block” [d] at the bottom shielding.
Figure 4-16 1080p panel
Figure 4-17 Bottom shielding 1080p panel
4.3.8
Small Signal Board (SSB)
1.
Remove the rear cover, as described earlier.
2.
Refer to figures “SSB removal” below.
3.
Disconnect all cables [a] on the SSB.
4.
Remove the T10 tapping screws [b] that hold the SSB. See
Figure “SSB removal”.
5.
Remove the screws that hold the CINCH and HDMI
connectors at the connector panel.
6.
Lift the SSB from the set.
Figure 4-18 SSB removal -1-
Figure 4-19 SSB removal -2-
4.3.9
Main Supply Panel
1.
Remove the rear cover, as described earlier.
2.
Refer to fig. “Main supply panel” below.
3.
Unplug cables [a].
4.
Remove the fixation screws [b].
5.
Take the board out (it hinges at the left side).
Figure 4-20 Main supply panel
G_16860_089.eps
150307
b
c
a
c
b
c
c
G_16860_088.eps
150307
d
H_17260_036.eps
050707
a
a
b (2x)
b (3x)
b (3x)
b (2x)
H_17260_037.eps
050707
b
b
b
b
b
G_16
8
60_065.ep
s
010207
a
a
a
b (
3
×)
