Philips LBB 2541/10, Инструкция по установке и эксплуатации, Страница: 13 / 19

13
Eng
Note: The red mode indicator LED (item 3) will flash while a message is being recorded.
7. When the message is complete, stop the recording using the start/stop button (item 7) or
the microphone switch. The red mode indication LED will stop flashing (but remains on).
Note: If the memory for the message being recorded becomes full, the RMM automatically stops
recording, and the red mode indicator LED stops flashing (but remains on).
Recording a message using the CS-B/CX-B
To record a message using the CS-B:
1. Ensure that the configuration settings for the CS-B/CX-B and CSM, for example priority
settings and chime tone are correctly made. For more information, refer to the relevant
Instructions for use and Installation Instructions.
Note: It is not possible to make a recording using the CS-B unless zone selection is carried out. If no
zones have been selected, the CS-B will generate an error message. Any messages recorded using the
CS-B will be distributed to the SM 25B system bus via the CSM, and will therefore be distributed to
the selected zones while recording is taking place. It may therefore be necessary to make such record-
ings when the public address venue is not being used, or with the speaker outputs disconnected.
2. Press the mode selector push button (item 6) until the yellow indicator LED (item 4) is on
(monitor mode).
3. Press the message select push button (item 8) until the required message number is dis-
played on the message indicator (item 5).
Note: A total of 10 message can be recorded (numbered 0 to 9). Continually pressing the message
select push button will toggle through all 10 messages. Any message number that is empty i.e. has no
recorded message will flash alternately with a ‘-’ symbol.
4. Make the required zone selection settings using the CX-B.
5. Press and hold the PTT button to start recording.
Note: The red mode indicator LED (item 3) on the RMM will flash while a message is being recorded.
6. Record the message.
7. When the message is complete, release the PTT button to stop the recording. The red
mode indication LED (item 3) will stop flashing (but remains on).
3.2 Deleting a message
To delete a message:
1. Press the mode selector push button (item 6) until the yellow indicator LED (item 4) is on
(monitor mode).
2. Press the message select push button (item 8) until the required message number is
displayed on the message indicator (item 5).
3. Press the mode selector push button (item 6) until the red indicator LED (item 3) is on
(record mode).
4. Press and hold the mode selector push button for at least 2 seconds. The message
number on the pre-selected message indicator will flash.
5. Press the start/stop button (item 7) to delete the message.
Note: If the mode selector push button is pressed instead of start/stop, the delete is cancelled.