Philips L06.1E, Руководство по обслуживанию

Страница: 11 / 78

Mechanical Instructions EN 11 L06.1E 4.
4.4.4 Large Signal Panel (LSP)
Figure 4-7 LSP locking handles
1. Simultanuously do the following:
a.
Pull the two plastic locking handles at the mid left and
mid right side of the bracket gently backwards to
unlock the bracket (see Figure “LSP locking handles”),
and
b. Loosen the bracket from the bottom tray, by pulling it
backwards.
N.B.: You do not need to pull the other two locking
handles backwards.
2. Remove the LSP-bracket from the bottom tray by lifting it
upwards.
3. Remove all cables from the LSP.
4. Remove the board from the bracket by unhooking it from its
fixation clamps.
4.5 Set Re-assembly
To re-assemble the whole set, do all processes in reverse
order.
Be sure that, before the rear cover is mounted:
•
The mains cord is postioned correctly in its guiding
brackets (make sure that the strain relief will function
correctly!).
• All wires/cables are returned in their original positions. This
is very important, in view of the “hot” and “EHT” areas of the
set.
• Check if no wires are touching the heat sinks that are on
the LSP; this may dammage the cables!
G_16350_045.eps
060406
1 1