Mechanical Instructions
4.
4.
Mechanical Instructions
Index of this chapter:
Note:
Figures below can deviate slightly from the actual
situation, due to the different set executions.
4.1
Rear Cover Removal
1.
Remove all (seven) fixation screws of the rear cover: two at
the top, two at each side and one near the mains cord
holder.
2.
Now pull the rear cover backward to remove it.
4.2
Service Position Main Panel
1.
Disconnect the strain relief of the Mains cord.
2.
Remove the main panel, by pushing the two centre clips
outward [1]. At the same time, pull the panel away from the
CRT [2].
3.
Disconnect the degaussing coil by removing the cable from
(red) connector 0201.
4.
Move the panel somewhat to the left and flip it 90 degrees
[3], with the components towards the CRT.
Figure 4-1
4.3
Side I/O Panel Removal (if present)
1.
Remove the complete Side I/O assembly, after unscrewing
the 2 fixation screws [1].
2.
Release the two fixation clamps [2] and lift the board out of
the bracket.
Figure 4-2
4.4
Rear Cover Mounting
Before you mount the rear cover:
1.
Place the mains cord correctly in its guiding brackets
(strain relief).
2.
Place all cables in their original position.
A
B
1
CL 16532016_006.eps
220501
2
1
3
CL 06532012_004.eps
030200