Philips IntelliVue Series, Инструкция по установке и обслуживанию

Страница: 216 / 522

Network Names and IP Addresses
5-36
Hardware Installation
this window. Note that the default
Subnet Mask
and
Default Gateway
address are also
shown.
Figure 5-34 IP Address from Control Panel on Windows XP/2000 Device
Setting Host
Names and IP
Addresses
After all Network devices have been installed, their
Host Names
and
IP Addresses
should
be set. Philips workstations and the Server should have their
Host Names
changed to
something associated with their setting or application. All Network devices -- Information
Centers, Clients, Server, Switches, Printers -- must also have their
IP Addresses
set before
Philips software can be installed and configured.
Notes IP Addresses for M3/M4/IntelliVue Patient Monitors are automatically assigned by Philips
software.
Network Installation Worksheets
are provided in
Appendix A
to record
Host
and
Device Names
, hospital
Locations
, and
IP Addresses
. Complete these
Network
Installation Worksheets
for all devices on the Network.
Information
Centers, Clients,
Patient Link, and
Small Database
Server
The following steps describe how to set
Host Names
and
IP Addresses
for Information
Centers, Clients, and Small Database Servers. After these have been set, the
Network
Interface Card
(NIC) configuration must also be verified. That procedure follows.
Step 1. Click on Start , Settings and Control Panel to open the Control Panel .
Step 2. Double click on the
System
icon in the
Control Panel
window to open the
System Properties
window of
Figure 5-33
.
Step 3. Change the Computer Name for this device to a Host Name associated with its
location in the hospital, e.g. ICU, CCU.