Philips HX3212/01, Руководство пользователя, Страница: 17 / 60

4 Remove the end cap from the toothbrush handle. If the end cap
does not release easily from the housing, repeat step 3 until the
end cap is
released (Fig. 13) .
5 Holding the handle upside down, press the shaft down on a hard
surface. If the internal components do not easily release from the
housing, repeat step 3 until the internal components are
released
(Fig. 14) .
6 Remove the inner assembly from the housing by fully inserting a
small flat-head screwdriver into the slot opposite the circuit board
and pry until it comes
apart (Fig. 15) .
7 Grab the battery and pull it out of the internal assembly (Fig. 16) .
Caution: Be aware of the sharp edges of the battery tabs so as
to avoid injury to your fingers.
8 Cut the battery wires from the circuit board close to the battery
(Fig. 17) .
9 Cover the battery contacts with tape to prevent any electrical short
from residual battery charge. The rechargeable battery can now be
recycled and the rest of the product discarded appropriately.
Guarantee and support
If you need information or support, please visit
www.philips.com/
support or read the separate worldwide guarantee leaflet.
Guarantee restrictions
The terms of the international guarantee do not cover the following:
-
Brush heads.
-
Damage caused by use of unauthorised replacement parts.
-
Damage caused by misuse, abuse, neglect, alterations or
unauthorised repair.
-
Normal wear and tear, including chips, scratches, abrasions,
discolouration or fading.
English
17
4235_021_0743_2_Booklet_Simple_A6_3mm_v4.indd 17 24/11/16 13:29