10
EN
Refilling reservoir
Water level can be seen through the
transparent reservoir window.
1
Turn off the humidifier and remove
the plug from the electrical outlet.
2
Remove the upper unit by holding it
at both sides (fig.
c
).
3
Pour out any remaining water, rinse
reservoir, wipe clean and dry with a
clean cloth or paper towel.
4
Refill reservoir with cold tap
water until the water reaches the
maximum water indication level
(fig.
d
). Do not overfill.
Note
•
When filling water, do not exceed the
maximum water level, or water might
leak from the drain hole and air inlets.
•
Do not shake the reservoir when moving
it, or water might leak from the drain
hole and air inlets.
•
Do not fill water through the air outlets
on top of the humidifier.
•
Always use 2 hands when moving or
carrying the humidifier.
•
The appliance can run approximately
12 hours at speed 3 under 45% RH with a
full reservoir.
5
Place the upper unit back onto the
reservoir (fig.
e
).
Note
•
Clean the reservoir and the filter once a
week to keep it hygienic.
Tip
•
A comfortable humidity level is from
40RH% to 60RH%. You can choose
the preferred humidity level at 40%RH,
50%RH or 60%RH.
Note
•
If no preset humidity level is selected,
the humidity indication light will be off.
Water level
When there is not enough water in the
reservoir:
•
The red indicator light starts
blinking (fig.
f
).
•
The humidifier will stay on for
30 minutes and then turns off, and
the red indicator light remains on.
You can turn the humidifier back on
after refilling water into the reservoir.
Note
•
If the reservoir is empty when the
humidifier is plugged in and turned
on, the red indicator light blinks for
2 minutes and then remains on before
the reservoir is refilled with water.
•
It is normal to find some water left in the
reservoir.
