Philips Heartstart XLT, Руководство по обслуживанию

Страница: 104 / 224

External Assemblies
4 - 18 Removal and Replacement
the Eject Button out of the case. The catch is located in the narrow slot in
the bottom case that points to the eject button. Note the orientation of the
Eject Button.
3. Pull the Battery Eject Catch up out of its slot in the case. There will be a
long spring inside the catch. Note the orientation of the catch in its slot.
Replacement
1. Insert the new Battery Catch Spring into the hole in the end of the new
Battery Eject Catch.
2. Install the Battery Eject Catch into its open slot in the bottom case, with
the spring on the end furthest from the Eject Button and the triangular
plastic catch facing up toward you through the top of the open slot.
3. Install the Battery Eject Button into its hole in the bottom case. Push the
Eject Button all the way in to engage its catch and prevent it from falling
back out. Check to be sure the Eject Button and Eject Catch slide freely
and operate correctly.
4. Replace the battery cover as described under "Battery Cover" on page 4-
15.
Data Card Door
Removal
1. Open the door. This will expose the shaft on which the door pivots. Note
the spring wrapped around the shaft.
2. Using a small flat bladed screwdriver, catch the right end of the pivot
shaft and slide it toward the center, compressing the spring. When the
spring is compressed enough, the pivot shaft will pop easily out of its hole
in the bottom case.
3. Remove the door.
Replacement
1. The new door comes complete with the black latch, the pivot shaft and the
spring already installed in the door.
2. Check to be sure the pivot holes in the case have not been damaged. If
they have been, the Bottom Case Assembly must be replaced.
3. Insert one end of the pivot shaft into the hole on the defibrillator case.
Compress both ends of the pivot shaft against the spring and snap the door
into place.
4. Check to be sure the door moves freely, latches securely, and springs open
when unlatched.