Philips FWD576, Руководство пользователя

Страница: 19 / 49

19
English
Preparations
Step 2: Setting the clock
The clock can be set in either 12-hour or 24-
hour mode (“
PM 00
:
00
” or “
00
:
00
” for
example).
1
The clock can be set in any source mode.
➜
If you have not set the clock, “--:--” will be
shown on the display.
2
Press and hold
CLOCK
and “
00
:
00
” blinks on
the display.
➜
The current time is flashing on the display.
➜
If you have not set the clock, “--:--” will appear
on the display.
3
Press
O
or
P
on the system to set the
hours.
4
Press
1
or
¡
on the system to set the
minutes.
5
Press CLOCK to confirm your setting. Clock
will be shown on the display for 5 seconds and
then go back to it’s previous status. The system
will store the setting automatically.
➜
The time setting becomes effective.
To exit the setting without storing (in
standby mode)
●
Press
9
on the system to exit.
➜
“
CANCEL
” will appear on the display.
●
Press
ECO POWER/ STANDBY ON
to exit
setting mode and go into
ECO POWER
mode.
●
You can also press
DISC
,
DISC1~3
,
DISC
CHANGE
,
OPEN•CLOSE
to exit setting
mode and go into disc mode.
●
The system will also exit setting mode and go to
TUNER, TAPE or AUX/GAME mode when you
press the corresponding source button.
Viewing the clock in any source mode
●
When you have set the clock, press CLOCK on
the system to view clock (or press CLOCK/
TIMER
on the remote control). Press
DISPLAY on the system to toggle between 12-
hour and 24-hour modes.
➜
The time will be displayed for 5 seconds and
then go back to it’s previous status.
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
3
2
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3
Close the cover.
Using the remote control to operate the
system
1
Point the remote control directly
at the remote sensor (iR) on the
front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE1/2, TUNER).
3
Then select the desired function (for example
2;
,
O
or
P
).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
P001-P049_FWD576_Eng 2005.5.16, 2:02 PM 19