FC7020/01 /71 /81
2-6
• To replace the Rotating Brush (
14
) of the nozzle:
Turn the appliance upside down, open the Roller Brush
cover (
18
) by lifting it. Take the brush out by lifting it on
the right side and moving it out sideways to the right.
1
2
• To place the Brush, position the Brush over the Roller
Holder assy (
13
) then “click” the Brush into place at the
Roller Brush cover and close the Roller Brush cover.
1
2
3
• To replace the Brush Motor (
15
), Driving belt (
12
) and
Roller Holder assy (
13
):
Remove the 10 screws (
D
) on the bottom of the Nozzle
and push the 3 clicknocks on the front side with a
screwdriver, now the components can be reached.
• To replace the pump (
10
):
First remove the Water Tank (
3
) and Filter assy (
4
).
Remove the 4 screws (
C
), and remove the cover.
Now the pump is visible. Remove the clips from the
hoses and the valve and replace the pump.
C
C
C
C
Remark:
• You can use the delivered Pin (
5
) in the small plastic bag
for “unclogging” the little hole on the bottomside of the
Nozzle in case some calcium is present in the hole.
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
