Playing a disc
With this set you can play
–all pre-recorded audio CDs
–all finalized audio CDRs and CDRWs
–MP3-CDs (CD-ROMs with MP3 files)
1
Push the OPEN
2
slider to open the CD lid
.
2
Insert a disc, printed side up, by pressing gently on the
disc´s centre so that it fits onto the hub. Close the lid
by pressing it down.
3
Press
2;
to start playback.
.
y
r
rE
EA
Ad
d
d
di
iS
SC
C
are displayed briefly when reading
the contents of the disc.Press
2;
again to start
playback. For audio CD tracks, the current track
number and the elapsed playing time are dis
played. For a MP3 track, the album number, track
number and the elapsed time and MP3 icon are
displayed.
4
Press
9
to stop playback.
y
The total number of tracks and the total playing
time of an audio disc are displayed.
y
The total number of albums and tracks of MP3-
CD are displayed.
5
To remove the disc, hold it by its edge and press
the hub gently while lifting the disc.
6
Press
9
again to switch off the player.
Notes:
- After pressing
2;
it may take some time to read the
disc until the first MP3 track is played.
- The set switches off automatically after 70 seconds, if no control is operated
in the stop mode.
OP
EN
VOL
E
O
FF
• R
SU
M
E •
HO
LD
OUT
LINE
/
OP
EN
VOL
E
O
FF
• R
SU
M
E •
HO
LD
OUT
LINE
/
O
FF
• RE
S
U
M
E
• H
OL
D
LIN
E O
UT /
OPEN
This set complies with the radio interference requirements of the
European Community.
CD player and CD handling
• Do not touch the lens
A
of the CD player.
• Do not expose the unit, batteries or CDs to humidity, rain, sand or excessive
heat (caused by heating equipment or direct sunlight).
• You can clean the CD player with soft, slightly
dampened and lint-free cloth. Do not use any clean-
ing agents as they may be corrosive.
• To clean the CD, wipe it in a straight line from the
center toward the edge using soft and lint-free cloth.
A cleaning agent may damage the disc! Never write
on a CD or attach a sticker to it.
• The lens may cloud over when the unit is moved suddenly from cold to warm
surroundings. Playing a CD is not possible then. Leave the CD player in a warm
environment until the moisture has evaporated.
• Active mobile phones in the vicinity of the CD player may cause malfunctions.
• Avoid dropping the unit as this may cause damage.
Volume and bass
Volume adjustment
• Adjust the volume by using VOL
E
.
Sound Adjustment
1
Press DBB once or more for a moderate bass
enhancement (DBB1) or a strong bass enhancement
(DBB2).
y
is shown in the display
2
Press DBB again to switch the bass enhancement off.
y
disappears
In-car use (supplied or optionally available)
Only use a
4.5 V DC
car voltage converter (positive pole to the center pin)
and cassette car adapter. Any other converter may damage the set.
1
Put the set on a horizontal, vibration-free and stable surface. Make sure it is
in a safe place, where the set is neither a dan-
ger nor an obstacle to the driver and the pas-
sengers.
2
Plug the voltage converter into the
cigarette lighter jack
(only for 12 V car
battery, negative grounding)
, then connect
the wired end with 4.5V DC input jack on the
set.
3
If necessary, clean the cigarette lighter jack to
obtain a good electrical contact.
4
Turn down the volume and connect the cassette adapter plug to LINE OUT/
p
on the set.
5
Carefully insert the cassette adapter into the car radio’s cassette compartment.
6
Make sure the cord does not hinder your driving.
7
Decrease the volume on the set if necessary. Start playback on the set and
adjust the sound with the car radio controls.
•
Always remove the voltage converter from the cigarette lighter jack-
when the set is not in use.
Note:
If your car radio has a LINE IN jack, it is better to use it for the car radio con-
nection instead of the cassette adapter. Connect the signal lead to this LINE IN
jack and to
LINE OUT/
p
on the set.
OPEN
VO
L
E
O
F
F
•
R
S
U
M
E
•
H
O
L
D
O
U
T
LIN
E
/
4,5 V DC
12 V DC
GENERAL INFORMATION
GENERAL INFORMATION/CD PLAY
MP3 music files
Note:
The following formats are not supported:
- *.WMA* , *.AAC*, *.DLF*, *.PLS*, MP3 PRO
- Non-session closed discs
How to organize music files
In order to easily handle the large number of music files on a CD-ROM, you
can organize them in folders (“albums”).
The tracks of an album will be played in alphabetical order. If you want to
arrange them in a certain order, let the file names start with numbers.
For example:
001
-ONEWORLD.MP3
002
-FIRESTARTER.MP3
003
-DEEP.MP3
The albums will be arranged in alphabetical order. If albums are located in an
album, they will be played after this album. Albums without MP3 files will be
skipped.
If there are MP3 files which you did not put into an album, you will find them
in the album number 1.
How to make a CD-ROM with MP3
Use your computer´s CD burner to record (“burn”) the music files from your
hard disk on a CD-ROM. Use either ISO 9660 disc format or UDF. Some CD
burner software like e. g. “Drag-to-Disc” or ”InCD” supports the UDF format.
Make sure that the file names of the MP3 files end with .mp3.
DBB1 DBB2
