Firmware upgrade
Occasionally, Philips releases new software (“firmware”) for your set.
1
Connect the mains adapter to 4.5V DC on the set and to the wall socket
(see “Mains adapter”).
2
Keep MODE pressed for 3 seconds.
➜
The type of your set and the current version
of the firmware are displayed.
Upgrade?
is
displayed.
3
Press
9
.
4
Visit the Philips Audio homepage www.audio.philips.com. Check if there
is a firmware file for your set and if the firmware version is higher than
the current version of your set. Download the file and burn it on an
8 cm CD-ROM.
5
Insert the CD-ROM into the set and keep MODE pressed for 3 seconds.
➜
Upgrade?
is displayed.
6
Press
2;
:
➜
Upgrading
is displayed and upgrading starts.This may take some minutes.
After upgrading is finished,
Upgrade complete
is scrolled.
➜
Wrong upgrade file
is scrolled:Your set already has the latest firmware
or the downloaded file does not correspond to your set.
➜
Upgrade file defect
is scrolled:The upgrade file has been damaged
during the download or when burning the CD-ROM. Download the file
again, burn a new CD-ROM and try again.
➜
No upgrade file
is scrolled: No upgrade file was found on the inserted
CD-ROM.
Note: If upgrading is interrupted accidentally, repeat steps 5 and 6 until upgrading
is completed successfully.
12
General information
English
ALB
UM
ALBUM
SEARCH
PLA
Y
ST
OP
DIS
PLA
Y
M
OD
E