1
EN
1 Important
Safety
Warning
•
Never remove the casing of this speaker.
•
Never place this speaker on other electrical
equipment.
•
Keep this speaker away from direct
sunlight, naked flames or heat.
•
Only use attachments or
accessories specified by the
manufacturer.
•
The battery shall not be exposed
to excessive heat such as sunshine,
fire or the like.
•
Do not place any sources of
danger on the speaker (e.g. lighted
candles).
•
The speaker can meet IP57
waterproof standard only when
the USB/AUDIO IN socket cover is
covered seamlessly.
•
If your speaker gets wet, clean with
a soft dry cloth and then let it dry
completely in a well-ventilated
place before use next time.
•
The operation temperature of the
product is from -10 °C to 40 °C.
•
For safety reasons, the battery
will not be charged if the battery
temperature is below 0 °C or above
40 °C.
Note
•
The type plate is located on the back of
the speaker.
Notice
Any changes or modifications made
to this device that are not expressly
approved by Gibson Innovations may
void the user’s authority to operate the
equipment.
Notice of compliance (for the
USA and Canada)
The device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1
This device may not cause harmful
interference, and
2
This device must accept any
interference received, including
interference that may cause
undesired operation.
FCC rules
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instruction manual, may
cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
•
Relocate the receiving antenna.
