10
Note
If you are not going to use the remote control for a long
time, remove the battery.
Set clock
1
In standby mode, press
CLOCK
for 3 seconds
to activate clock setting mode.
»
[SET CLOCK]
scrolls on the display, then
the time format
[24H]
and
[12H]
appears.
2
Press
ALBUM/PRESET
to select 24H or 12H,
then press
CLOCK
WRFRQÀUP
The hour digits begin to blink.
»
3
Press
ALBUM/PRESET
to set hour, then press
CLOCK
again.
The minute digits begin to blink.
»
4
Press
ALBUM/PRESET
to set minute.
5
Press
CLOCK
WRFRQÀUPWKHFORFNVHWWLQJ
Note
If no button is pressed in 30 seconds, the system exits
clock setting mode automatically.
Turn on
1
Press .
The unit switches to the last selected
»
source.
Switch to standby mode
1
Press for over 3 seconds to switch the unit
to Eco Power Standby mode.
The backlight on the display panel turns off.
»
The blue Eco Power indicator turns on.
»
To switch the unit to standby mode:
1
In Eco Power Standby mode, press for over
3 seconds.
The clock (if set) appears on the display
»
panel.
The blue Eco Power indicator turns off.
»
Store radio stations automatically
When the unit is connected to power and no radio
stations are stored, the unit begins to store radio
stations automatically.
1
Connect the unit to power supply.
»
[AUTO INSTALL PRESS--PLAY KEY]
(auto
install press - play key) is displayed.
1
Connect the power cable to:
the
AC~
jack on the main unit.
the wall socket.
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
VXQVKLQHRUÀUH1HYHUGLVFDUGEDWWHULHVLQÀUH
)RUÀUVWWLPHXVH
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control batteries:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
EN
DCM377_05_UM_V1.1.indd 10
2010-9-29 16:46:51