TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING:
Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!
No sound
–
Volume not adjusted.
• Adjust the volume.
Display error / no reaction to any controls
–
Electrical malfunction.
• Press the
RESET
hole on the bottom of the set with a ball-pen.
Intermittent crackling sound during FM reception
–
Weak signal.
• Extend and position the FM/DAB pigtail antenna.
The alarm does not function
–
Alarm time/ mode not set.
• See
SETTING THE ALARM TIME
.
–
Volume too low for radio.
• Increase the volume.
The indication “No station available” is displayed.
–
DAB coverage is currently not available in your area.
• Wait until the coverage resumes.
–
DAB signal is weak.
• Re-locate the set, or adjust the position of FM/DAB pigtail antenna.
The indication “Station off air” is displayed.
–
The station is currently out of service.
• Wait until the service resumes. Or, perform a scan by pressing
AUTO-SCAN
in
DAB mode.
Poor reception
–
Signal strength is weak.
• Re-locate the set, or adjust the position of the FM/DAB pigtail antenna. For
DAB, you may also perform manual tuning. See
Manual tune
.
I cannot hear the DAB station I have selected.
–
2;
button was not pressed after changing a station by pressing
/-
.
• Press
2;
button to confirm the selection.
Note:
In case of malfunciton due to electrostatic discharge, just reset the product
(Reconnection of power source may be required.) to resume normal operation.
DCB310_05_CCR 6/27/08 15:33 Page 10
