Philips CED781, Руководство пользователя

Страница: 15 / 52

13
EN
Connect the GPS antenna
1
Connect the GPS antenna to your car
navigation system.
2
Use the supplied screw to fasten the
connectors.
Install the GPS antenna
You can install the signal receptor of GPS antenna:
• On the dashboard cover
• On the back panel of rear-view mirror
Note
•
Make sure that the contact surface that contacts with
the metal sheet is free of moisture, dust, grime, oil, and
any other dirt.
•
If you remove the metal sheet, some adhesive may be
left on the contact surface.
GPS AERIAL
a b
a
b
c
1
Remove the protective cover of the metal
sheet, and then affix it.
2
Affix the antenna box onto the metal sheet.
3
Use clamps to secure the antenna cable.
Mount into the dashboard
Note
•
Check wire connection before you mount the unit
into a car.
•
If preset radio stations are lost when the ignition key is
turned off and then turned on, reconnect the red leads
crosswise to the yellow ones.
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that the
bare wires do not touch each other.
2
Ensure that car dashboard opening is
within these measurements:
• Since the unit cannot be used if the
slant angle of dashboard opening is
above 20 degrees, ensure that the
horizontal slant of the dashboard
opening is between 0 and 20 degrees.
183 mm
53mm
5mm