4
EN
3 Setup
Always follow the instructions in this
chapter in sequence.
These instructions are for a typical
installation. However, if your car has
different requirements, make the
adjustment accordingly. If you have
any question regarding installation kits,
consult your local retailer.
Note
•
This system is designed for negative
ground (earth) 12V DC operation only.
•
Always install this system in the car
dashboard. Other locations can be
dangerous as the rear of the system heats
up during use.
•
To avoid short-circuit: before you connect,
make sure that the ignition is off.
•
Make sure that you connect the yellow and
red power supply leads after all other leads
are connected.
•
Make sure that all loose leads are insulated
with electrical tape.
•
Make sure that the leads do not get caught
under screws iron parts that will move (e.g.
seat rail).
•
Make sure that all ground (earth) leads are
run to a common ground (earth) point.
•
Use only the supplied mounting hardware
for a safe and secure installation.
•
Improper fuses can cause damage or fire.
When you need to change the fuse, consult
a professional.
•
When you connect other devices to this
system, make sure that the rating of the car
circuit is higher than the total fuse value of
all the connected devices.
•
Never connect speaker wires to the metal
body or chassis of the car.
•
Never connect speaker wires with stripes to
one another.
Connect wires
Note
•
Make sure that all loose leads are insulated
with electrical tape.
•
Consult a professional to connect wires as
instructed below.
•
Before connection, check the car's wiring
carefully.
1
Connect the ISO male connectors.
ISO male
connectors
Connect to
a
Green strip,
black-edged
green strip
Rear left speaker
b
White strip,
black-edged
white strip
Front left
speaker
c
Gray strip, black-
edged gray strip
Front right
speaker
d
Purple strip,
black-edged
purple strip
Rear right
speaker
e
Red strip
Ignition key +12V
DC when ON/
ACC
f
Blue strip
Motor/electric
antenna relay
control lead
