Philips CarStudio CEM2101R/51, Руководство по обслуживанию

Страница: 19 / 20

e. To check the normal voltage of 22 PIN(MUTE) of power amplifier IC501(TDA7388) , normally should be 4V.
7313 IC
R
d . To check the circuit of power amplifier IC501 (TDA7388) and VOL IC403 (7313IC).
2012-6-20
CEM2101
NO.
c. To check the voltage of the 7 pin(VDD) of the tuner , should be +3V3.
a. To check the antenna of the tuner.
e. To check the oscillation frequence of crystal XT001 of the tuner, should be 32.768KHZ.
3
b. To check whether the strength of then input signal of the tuner is too weak.
5DGLR
DEQRUPDO
f. To check the L output voltage of the 5 pin of tuner should be 1V5, the 6 pin R output voltage , should be 1V5.
d. To check the voltage of the 10 pin(RES) of the tuner, should be +3V6; the 11 pin(CLK) should be +3V1; the 12
pin(date) should be +2V8.
2 NO audio
output
f. To check the voltage of control PIN SDA
ǃ
SCL
˄
the 27
ǃ
28pin
˅
of audio processor IC403
˄ ˅
,
should be +3V3.
b. To check whether the unit is at MUTE mode, press SOURCE button and check whether it is effective of the
input sound source.
c. To check whether the connection of 8PIN audio output wire of ISO connector is correct; wrong connection or
short circuit to the ground will caused the protection of the power amplifier( no voltage output).
NO Power
a. To check whether the volume knob is turn to the minimum position.
g. To check Panel LED +5V voltage , should be normal.
a. To check whether it is connect well of the ISO connector (4PIN power input ). Whether it is loose of the 15A
fuse of the ISO connector, or insert non in place.
b. To check whether the reset button Sw201 is long term functional then caused short circuit and no power.
1
f. To check the oscillation frequence of crystal X201 , shuold be 8MHz, and for the crystal X202 should be
32.768KHZ.
d. To check the power supply of main board B+
ǃ
ACC should be +12V; The voltage of stabilivolt of ACC power
supply wire ZD210 (6V8) should be 6V8.
e. To check the voltage of the 19 pin (AVDD) of MCU (T5CL8) should be +3V3; The output voltage of IC307
(LM2950) should be +3V3.
c. To check whether there is any contamination and bad contact on the 22 Pin male/female connector on the
panel and main board.
failure cause
failure
phenomena
remark
7URXEOHVKRRWLQJ 7URXEOHVKRRWLQJ
$OO$UHD
Area Date
Product
Model
19