background image

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

! IMPORTANT SAFEGUARDS !

WHEN USING ELECTRICAL EQUIPMENT, BASIC

SAFETY PRECAUTIONS SHOULD ALWAYS BE 

FOLLOWED, INCLUDING THE FOLLOWING:

SAVE THESE INSTRUCTIONS

THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM BATTERY.  

THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.

© Philips Emergency Lighting

A Division of Philips Electronics North America Corporation 

236 Mt. Pleasant Rd. • Collierville, TN USA 38017-2752 • Tech Support 888-263-4638 • Fax 901-854-1630 • 

www.philips.com/bodine

73000001

Installation Instructions

  1.  To prevent high voltage from being present on red & yellow output leads prior to installation, inverter

 

    connector must be open. Do not join inverter connector until installation is complete and AC power is 

 

    supplied to the emergency ballast.
  2.  This product is for use with most 2' through 8' (17 W - 215 W) T5, T8, T9, T10 and T12 single pin or 
    bipin fluorescent lamps, including energy saving, circline, U-shaped and rapid-start (4-pin) long 
    compact fluorescent lamps.

 3. 

Make sure all connections are in accordance with the National Electrical Code or Canadian Electrical Code 

 

    and any local regulations.
  4.  To reduce the risk of electric shock, disconnect both normal and emergency power supplies and battery  

 

    connector of the emergency ballast before servicing.

  5.  This emergency ballast is for factory or field installation.
  6.  This product is suitable for damp locations where the ambient temperature is +5°C minimum, +50°C 
    maximum. Not suitable for heated air outlets and wet or hazardous locations.
  7.  An unswitched AC power source is required (120 or 277 VAC, 60 Hz).
  8.  Do not install near gas or electric heaters.
  9.  The use of accessory equipment not recommended by the manufacturer may cause an unsafe 

   condition.

 10.  Do not use this product for other than intended use.
 11.  Servicing should be performed by qualified service personnel.

CAUTION:

 Verify that all replacement lamp types marked on the installed luminaire are also identified as suitable for 

use with this inverter/charger pack.

B30

EMERGENCY LIGHTING EQUIPMENT

12/10/13

Ni - Cd

NRTL/C

Содержание bodine B30






Отзывы: