Philips BJ3.0E, Руководство по обслуживанию

Страница: 14 / 176

Mechanical Instructions EN 14 BJ3.0E PA 4.
Now the AmbiLight lamp units can be removed from the frame.
Each of them is fixed with four T10 parker screws: two on the
inside and two on the outside of the frame.
4.3.13 LED Panel
1. After the AmbiLight diffusor frame has been removed, the
LED Panel is accessible.
2. Remove the T10 mounting screws that hold the panel.
3. Take out the panel.
When defective, replace the whole unit. Reconnect the earth-
cable during re-assembly.
4.3.14 Plasma Display Panel / Glass Plate
Before removing the PDP, related panels and the glass plate,
the primary and secondary chassis frames have to be
removed.
Primary Chassis Frame Removal
Figure 4-19 Primary chassis frame removal
1. Take out the SSB and main I/O panel as previously
described.
2. Remove the T10 parker screws [1].
3. Remove one T10 tapping screw [2] that connects the top
frame with the bottom frame.
4. Remove two supply cables [3] that connect the PDP supply
panel with the platform supply panel from their clamps.
5. Remove the cable tie [4] of the ferrite core. During re-
assembly, replace it by a new one.
6. Disconnect two cables [5] from the Audio Panel.
7. Disconnect one cable [6] from the Platform Supply Panel.
8. Remove the LED Panel as previously described without
disconnecting the cable. Release the cable from its clamps
and place the panel in the middle of the set.
9. Now the primary chassis frame can be lifted, together with
the Side I/O-, the LED- and the Control Panel. See Figure
“Primary chassis frame lift”.
G_15960_108.eps
080306
2 3
2 4
2 5
2
1
1
6
3 2