Problem solving
If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline
(see next paragraph) or consult your dealer.
Under no circumstances should you try to repair the set yourself as this will
invalidate the guarantee.
Problem
Possible cause
Solution
SYSTEM check light
Parent Unit
does not light
Unit is not switched on.
Turn the ON VOLUME OFF control to ON.
Power adapter is not plugged in or
Plug in power adapter or recharge
batteries are empty.
batteries
Baby Unit
Unit is not switched on.
Press POWER button.
Power adapter is not plugged in or
Plug in power adapter or replace batteries.
batteries are empty.
High pitched noise
Units are too close to each other.
Move Parent Unit away from Baby Unit.
Volume too high.
Decrease the Parent Units volume.
No sound
Volume on Parent Unit is set too low.
Increase Parent Unit volume.
Sensitivity setting on Baby Unit too low. Adjust sensitivity level of Baby Unit.
Units are out of range.
Move Parent Unit closer to Baby Unit.
SYSTEM check light
Baby Unit not switched on.
Press POWER button.
blinks red and/or
system check alarm
Power adapter of Baby Unit is not
Plug in power adapter or replace batteries.
on Parent Unit
plugged in or batteries are empty.
beeps
Contact between units is interrupted
Reposition the units. Baby Unit first.
Units too far away from each other.
Decrease distance between units.
Batteries are low.
Replace/recharge batteries.
Interference from another RF source.
Remove the other RF source.
ENGLISH
16
XP SBC SC 490 14-02-2003 16:43 Pagina 16
