Philips AZ5140, Руководство по обслуживанию

Страница: 8 / 29

3 - 3
TROUBLESHOOTING
Problem Solution
CD/VCD OPERATION
"
NO DISC
" is displayed – Insert a disc.
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens has
cleared.
– Replace or clean the disc, see "Maintenance"
– Use a readable disc or correct recorded format
MP3-CD.
No picture on TV screen – Connect the cable between the system and TV.
No colour on TV – Change the system to the respective PAL or
NTSC setting.
RADIO RECEPTION
Radio reception is poor – If the signal is too weak, adjust the antenna
for better reception.
– Increase the distance between the Receiver
and your TV or VCR.
TAPE OPERATION/RECORDING
Recording or playback cannot be made
– Clean deck parts, see "Maintenance".
– Use only NORMAL (IEC I) tape.
– Apply a piece of adhesive tape over the missing
tab space.
GENERAL
The system does not react when buttons – Slide the source sector to TAPE/OFF. Remove and
pressed/set does not work/no display on reconnect the AC power plug for 30 seconds and
LCD. switch on the set again.
Sound cannot be heard or is of poor – Adjust the volume.
quality – Make sure the MP3-CD was recorded within
32-320 kbps (128kbps preferably) with sampling
frequencies at 8 - 48 kHz (44.1kHz preferably).
The remote control does not function – Reduce the distance between the remote control
properly and the system.
– Insert the batteries with their polarities (+/- signs)
aligned as indicated.
– Replace the batteries.
– Point the remote control in the direction of the
system's IR sensor.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
CONNECTIONS AND CONTROLS
GENERAL OPERATION
1.
Check if the mains voltage as shown on the type plate (on
the bottom of the set) corresponds to your local mains
voltage. If it does not, consult your dealer or service
organization.
2.
Connect the mains lead to the
AC MAINS
~
socket and the
wall socket.
™ The set is now ready for use.
3.
To switch off the mains supply completely, pull the mains plug out of the wall socket.
™ Disconnect the mains lead when you change over to battery supply, or to protect the set
during heavy thunderstorms.
The type plate is located on the bottom of the set.
1.
To switch on the set, adjust the source selector.
2.
Adjust the sound using the
VOLUME
and
DBB
controls.
3
To switch off the set, adjust the source selector to the
TAPE/OFF
position, with the cassette keys released.
1
Set the source selector to
FM
or
MW
.
2.
Adjust the sound using the
VOLUME
controls and the
DBB
switch.
3.
Tune to a radio station using the
TUNING
knob.
– For FM, pull out the telescopic aerial. To improve FM-reception,
incline and turn the aerial. Reduce its length if the FM-signal is
too strong (very close to a transmitter).
– For MW, the set is provided with a built-in aerial, so the
telescopic aerial is not needed. Direct the aerial by turning
the whole set.
4.
To switch off, set the source selector to the
TAPE/OFF
position (with the cassette keys released).
RADIO RECEPTION
GENERAL OPERATION
MAINS